• Excellent performance in wet conditions
  • Metal composite material with two material properties
  • Better wear-resistant than conventional resin
  • Smooth and consistent braking performance
  • Suitable for most weather and road conditions
  • Made in Taiwan

Product Description

FIN.TECH is PSB solution that makes heat dissipation brake pads are no longer exclusive to high-end users. The extensive use of this product improves the overall safety of bicycle riding. Lowering the temperature, not the demeanor.

Organic brake pad adds resin and fiber to the metal composite and metal fiber. This reduces the hardness to increase the braking effect. It combines the advantages of the two materials and makes the film more wear-resistant than traditional resin. Except It is suitable for most weather and road conditions, and it performs particularly well in wet road conditions without generating noise.

TAIPEI CYCLE d&i awards 2022

Cycling is one of the most eco-friendly activities; But there is still room for improvement. To this end, PSB developed the dual airing technology to improve the heat management of the braking system. Thank TAIPEI CYCLE d&i awards 2022 for recognition.

Replacement Notice

When the thickness of the brake pad reaches 0.5mm or less, replace it immediately. Then follow the bedding in instructions for primal performance.

Installation Precaution

Do not let any oil or lubricating agent get on the rotors and brake pads, otherwise it will affect the brake operation and cause safety issues.

High Temperature Precaution

Do not touch the calipers and the disc immediately after riding or getting off.

Rain Precaution

When it is rainy or the ground is slippery, a longer braking distance is required. Please reduce the speed and apply the brakes as early as possible. You may fall or collide and be seriously injured.


  • Brake Calipers
  • Level TL,T,Level
  • XX
  • XO
  • Elixir 9,5,3,1,CR,R

Check Before Every Ride

Before riding your bike, please check the following items


  •  ●  Are the thickness of all brake pads above 0.5mm ?
     ●  Are the rotors cracked or deformed ?
     ●  Are front and rear brakes both working properly ?
     ●  Is there any sign of brake fluid leakage ?
     ●  Are the levers firmly installed on the handle ?
     ●  Does the handle show signs of cracking or peeling ?
     ●  Is there any strange sound ?


※ If you have any questions, please consult the place of purchase or dealer

Upgrade Cooling Fins

Our design team and engineering team jointly developed a new solution for brake heat dissipation.



To ensure the best performance of the pads, please follow the bedding in procedure below.



Drag each brake for 30 seconds on a gentle downhill slope. Repeat 3 times, and switch between front and rear brake.


 Drag the brakes for 15 seconds then apply more pressure to the levers until the bike slowly stops. Repeat 3 times.


Repeat step2. with the rear brake for several times. This is to ensure all the pads are bedded evenly, due to the front pads are usually heated more.


※ Do not apply the front brake too strongly, the wheel may lock up and cause a forward bike fall with serious injury
※ Be aware of the high temperature before checking or replacing any brake related components