PI-R-2

  • Aluminum Alloy
  • Adapter *1
  • Bolts *2
  • Made in Taiwan

Product Description

This adapter allows the use of 180mm rotors with PM calipers on a IS rear frame.

Install The Adapter On IS Mounts

Recommended tightening torque:6 - 8 N·m

Setup Step

Follow the instructions

 

Step.1  Fix the adapter with the frame with M6 bolts.

Step.2  Slightly fix the caliper on the adapter.

Step.3  In order to prevent the caliper from rubbing against the rotor, press the brake lever before the screws are tightened. Make sure that the caliper is clamped on the rotor, then fully tighten the Bolts.

 

NOTICE : To prevent the caliper piston from protruding, please do not press the brake lever before the caliper is installed in the correct position.

 

※ If you have any questions, please consult the place of purchase or dealer

You May Need The Following Accessories

This adapter allows the use of 203mm rotors with PM calipers on a IS rear frame.

OTHER PM-IS ADAPTER

Check Before Every Ride

Before riding your bike, please check the following items

  •  

  • ●  Is the rotor thinner than the recommended thickness ? 

  •  ●  Is the installation direction correct (LOGO facing outwards) ?

     ●  Are front and rear rotors cracked or deformed ?

     ●  Does the screw or lock ring reach the recommended torque value?

     ●  When removing the rotor or cleaning the bike, the rotor should not be stained with oil

  •  

※ If you have any questions, please consult the place of purchase or dealer