FF-F-1

  • Aluminum Alloy
  • Adapter *1
  • Bolts *2
  • Made in Taiwan

Product Description

This adapter allows the use of 140mm and 160mm rotors on the front fork.

For the rear frame dropout, 160 mm rotors are allowed through this adapter (rear 140 mm does not require adapter).

For Front 140mm Rotors

Please refer to the information on the adapter
Recommended tightening torque:6 - 8 N·m

For Front 160mm Rotors

The front and back side of this adapter are both functional
Please refer to the information on the adapter.
If the rotor is 160mm, place the 160mm information side up
Recommended tightening torque:6 - 8 N·m

Setup Step

Follow the instructions

 

Step.1  Fix the adapter with the caliper.

Step.2  Slightly fix Step.1. on the bike with bolts.

Step.3  In order to prevent the caliper from rubbing against the rotor, press the brake lever before the bolts are tightened. Make sure that the caliper is clamped on the rotor, then fully tighten the Bolts.

 

NOTICE : To prevent the caliper piston from protruding, please do not press the brake lever before the caliper is installed in the correct position.

 

※ If you have any questions, please consult the place of purchase or dealer

You May Need The Following Accessories

This adapter allows the use of 160mm rotors on the rear frame dropout (rear 140 mm does not require adapter)

OTHER PM-FM ADAPTER

Check Before Every Ride

Before riding your bike, please check the following items

  •  

  • ●  Is the rotor thinner than the recommended thickness ? 

  •  ●  Is the installation direction correct (LOGO facing outwards) ?

     ●  Are front and rear rotors cracked or deformed ?

     ●  Does the screw or lock ring reach the recommended torque value?

     ●  When removing the rotor or cleaning the bike, the rotor should not be stained with oil

  •  

※ If you have any questions, please consult the place of purchase or dealer